Loading

Update Cisco certification 200-125 test questions

November 7, 2017| admin

If you still desperately cram knowledge and spend a lot of precious time and energy to prepare for passing Cisco certification 200-125 exam, and at the same time do not know how to choose more effective shortcut to pass Cisco certification 200-125 exam. Now Certpark provide you effective Cisco certification 200-125 test questions certification to pass Cisco certification 200-125 exam. It will play a multiplier effect to help you pass the exam.

If you participate in the IT exam, you should not hesitate to choose Certpark Cisco certification 200-125 test questions. After you use, you will know that it is really good. IT exam become more important than ever in today’s highly competitive world, these things mean a different future. Cisco 200-125 exam will be a milestone in your career, and may dig into new opportunities, but how do you pass CCNA Routing and Switching 200-125 exam? Do not worry, help is at hand, with Certpark you no longer need to be afraid.

Share some CCNA Routing and Switching 200-125 exam questions and answers below.
Which command enables IPv6 forwarding on a cisco router?

A. ipv6 host

B. ipv6 unicast-routing

C. ipv6 local

D. ipv6 neighbor

Answer: B

Which two states are the port states when RSTP has converged?(choose two)

A. blocking

B. learning

C. discarding

D. forwarding

E. listening

Answer: CD

Which technology supports the stateless assignment of IPv6 addresses (Choose two) ?

A. DNS

B. DHCPv6

C. DHCP

D. autoconfiguration

Answer: BD

Which three circumstances can cause a GRE tunnel to be in an up/down state? (Choose three.)

A. The tunnel interface IP address is misconfigured.

B. The tunnel interface is down.

C. A valid route to the destination address is missing from the routing table.

D. The tunnel address is routed through the tunnel itself.

E. The ISP is blocking the traffic.

F. An ACL is blocking the outbound traffic.

Answer: BCD

Which mode is compatible with Trunk, Access, and desirable ports?

A. Trunk Ports

B. Access Ports

C. Dynamic Auto

D. Dynamic Desirable

Answer: C

Which of the following correctly describe steps in the OSI data encapsulation process? (Choose two.)

A. The transport layer divides a data stream into segments and may add reliability and flow control information.

B. The data link layer adds physical source and destination addresses and an FCS to the segment.

C. Packets are created when the network layer encapsulates a frame with source and destination host addresses and protocol-related control information.

D. Packets are created when the network layer adds Layer 3 addresses and control information to a segment.

E. The presentation layer translates bits into voltages for transmission across the physical link.

Answer: A,D

Which command can you enter to set the default route for all traffic to an interface?

A. router(config)#ip route 0.0.0.0 0.0.0.0 GigabitEthernet0/1

B. router(config)#ip route 0.0.0.0 255.255.255.255 GigabitEthernet0/1

C. router(config-router)#default-information originate

D. router(config-router)#default-information originate always

Answer: A

Which two statements about IPv4 multicast traffic are true? (Choose two.)

A. It burdens the source host without affecting remote hosts.

B. It uses a minimum amount of network bandwidth.

C. It is bandwidth-intensive.

D. It simultaneously delivers multiple streams of data.

E. It is the most efficient way to deliver data to multiple receivers.

Answer: BE

Which two statements about northbound and southbound APIs are true? (Choose two.)

A. Only southbound APIs allow program control of the network.

B. Only northbound APIs allow program control of the network.

C. Only southbound API interfaces use a Service Abstraction Layer.

D. Only northbound API interfaces use a Service Abstraction Layer.

E. Both northbound and southbound API interfaces use a Service Abstraction Layer.

F. Both northbound and southbound APIs allow program control of the network.

Answer: BC

What will be the result if the following configuration commands are implemented on a Cisco switch?

Switch(config-if)# switchport port-security

Switch(config-if)# switchport port-security mac-address sticky

A. A dynamically learned MAC address is saved in the startup-configuration file.

B. A dynamically learned MAC address is saved in the running-configuration file.

C. A dynamically learned MAC address is saved in the VLAN database.

D. Statically configured MAC addresses are saved in the startup-configuration file if frames from that address are received.

E. Statically configured MAC addresses are saved in the running-configuration file if frames from that address are received.

Answer: B

A receiving host computes the checksum on a frame and determines that the frame is damaged. The frame is then discarded. At which OSI layer did this happen?

A. session

B. transport

C. network

D. data link

E. physical

Answer: D

Which layer in the OSI reference model is responsible for determining the availability of the receiving program and checking to see if enough resources exist for that communication?

A. transport

B. network

C. presentation

D. session

E. application

Answer: E

There are too many variables and unknown temptation in life. So we should lay a solid foundation when we are still young. Are you ready? Working in the IT industry, do you feel a sense of urgency? Cisco certification 200-125 test questions is the best training materials. Select the Certpark, then you will open your door to success. If you don’t purchase any course, although you spend a lot of time and effort to review of knowledge to prepare for Cisco certification 200-125 exam, it is still risky for you to pass the exam. 

Categories: Cisco

Leave a Reply

Your email address will not be published. Required fields are marked *

Rating*

Support