Loading

cisco 200-125 ccna available exam questions | Certpark

October 21, 2017| admin

So what you still waiting for, go to get new Certpark cisco 200-125 ccna available exam questions early.If you are still troubled for the Cisco 200-125 certification exam, then select the Certpark training materials please. Certpark cisco 200-125 ccna available exam questions are the best training materials, this is not doubt. Select it will be your best choice. It can guarantee you 100% pass the exam. Come on, you will be the next best IT experts.

Share some CCNA Routing and Switching 200-125 exam questions and answers below.
Which two statements about IPv6 router advertisement messages are true? (Choose two.)

A. They use ICMPv6 type 134.

B. The advertised prefix length must be 64 bits.

C. The advertised prefix length must be 48 bits.

D. They are sourced from the configured IPv6 interface address.

E. Their destination is always the link-local address of the neighboring node.

Answer: AB

Which three circumstances can cause a GRE tunnel to be in an up/down state? (Choose three.)

A. The tunnel interface IP address is misconfigured.

B. The tunnel interface is down.

C. A valid route to the destination address is missing from the routing table.

D. The tunnel address is routed through the tunnel itself.

E. The ISP is blocking the traffic.

F. An ACL is blocking the outbound traffic.

Answer: BCD

Which layer 2 protocol encapsulation type supports synchronous and asynchronous circuis and has built-in security mechanisms?

A. Frame Relay

B. HDLC

C. x.25

D. PPP

Answer: D

Which command can you enter to configure an IPV6 floating static route?

A. Router(config)# ipv6 route FE80:0202::/32 serail 0/1 201

B. Router(config)# ipv6 route::/0 serail0/1

C. Router(config)# ipv6 route static resolve default

D. Router(config)# ipv6 route FE80:0202::/32 serail 0/1 1

Answer: A

Which technology supports the stateless assignment of IPv6 addresses (Choose two) ?

A. DNS

B. DHCPv6

C. DHCP

D. autoconfiguration

Answer: BD

What will be the result if the following configuration commands are implemented on a Cisco switch?

Switch(config-if)# switchport port-security

Switch(config-if)# switchport port-security mac-address sticky

A. A dynamically learned MAC address is saved in the startup-configuration file.

B. A dynamically learned MAC address is saved in the running-configuration file.

C. A dynamically learned MAC address is saved in the VLAN database.

D. Statically configured MAC addresses are saved in the startup-configuration file if frames from that address are received.

E. Statically configured MAC addresses are saved in the running-configuration file if frames from that address are received.

Answer: B

For what two purposes does the Ethernet protocol use physical addresses? (Choose two.)

A. to uniquely identify devices at Layer 2

B. to allow communication with devices on a different network

C. to differentiate a Layer 2 frame from a Layer 3 packet

D. to establish a priority system to determine which device gets to transmit first

E. to allow communication between different devices on the same network

F. to allow detection of a remote device when its physical address is unknown

Answer: A,E

Which two statements about wireless LAN controllers are true? (Choose two.)

A. They can simplify the management and deployment of wireless LANs.

B. They rely on external firewalls for WLAN security.

C. They are best suited to smaller wireless networks.

D. They must be configured through a GUI over HTTP or HTTPS.

E. They can manage mobility policies at a systemwide level.

Answer: AE

Which command can you enter to set the default route for all traffic to an interface?

A. router(config)#ip route 0.0.0.0 0.0.0.0 GigabitEthernet0/1

B. router(config)#ip route 0.0.0.0 255.255.255.255 GigabitEthernet0/1

C. router(config-router)#default-information originate

D. router(config-router)#default-information originate always

Answer: A

Which command can you enter to determine whether serial interface 0/2/0 has been configured using HDLC encapsulation?

A. router#show platform

B. router#show interfaces Serial 0/2/0

C. router#show ip interface s0/2/0

D. router#show ip interface brief

Answer: B

With it, your exam problems will be solved. Certpark cisco 200-125 ccna available exam questions can help you to pass the exam easily. It has helped numerous candidates, and to ensure 100% success. Act quickly, to click the website of Certpark, come true you IT dream early.Certpark senior experts have developed exercises and answers about Cisco certification 200-125 exam with their knowledge and experience, which have 95% similarity with the real exam. 

If you add the cisco 200-125 ccna available exam questions of Certpark to your cart, you will save a lot of time and effort. Certpark product is developed by Certpark experts study of Cisco certification 200-125 exam, and it is a high quality product.Certpark promise that we will spare no effort to help you pass Cisco certification 200-125 exam. Now you can free download part of cisco 200-125 ccna available exam questions on Certpark. When you select Certpark, you can not only pass Cisco certification 200-125 exam, but also have one year free update service. 

Categories: Cisco

Leave a Reply

Your email address will not be published. Required fields are marked *

Rating*

Support